Skip to content
CH 11 · Part B: Doing a real tender properly

How to teach TrueQty your consultant's tag codes

Teach TrueQty a consultant's tag codes, layers and symbols once, so every later drawing your firm reads comes in already typed. Change or remove anything you taught in Settings.

Who can do this
Team leadAdmin

In this guide

  1. 01Unknown codes
  2. 02Set once
  3. 03Unrecognised layers
  4. 04Unrecognised symbols

Where to teach

Open the drawing and click the teaching button at the foot of Check each device type, such as Teach TrueQty 3 unknown symbols, or Typical floor and teaching TrueQty when there is nothing unknown. A panel called Teach TrueQty opens from the side, with everything TrueQty did not recognise on this drawing.

Unknown tag codes

Every consultant labels devices their own way. One uses CDC for a dome camera; another uses something else entirely. When TrueQty finds a code it does not know, it does not guess. It counts those devices only as a general type, and lists the code under Device types to set.

  1. Open Device types to set. Each code shows how many devices carry it, and what they are counted as now.
  2. Choose what the code means, and click Set device type.
  3. Its devices on this drawing take that type, and every later drawing with that code comes in already typed. The BOQ prices that type instead of a general one.

You teach it once, for your whole firm.

Layers, symbols and shapes TrueQty did not count

Further down the panel are Parts of the drawing TrueQty did not count (layers), Symbols TrueQty did not recognise (named CAD symbols) and Shapes TrueQty did not recognise: things on the drawing that nothing counted.

  1. Read each one. A layer holding 28 columns is not devices, so leave it as Not a device. Identical shapes are grouped, with a picture of each group.
  2. If one really is a device, choose its type and click Name it. TrueQty asks Teach everyone in your workspace that this is a ...?, because every drawing read from now on counts it. Click Teach everyone.
  3. Click Read again in the panel, to count it on this drawing. Naming applies to drawings read from now on. Reading an approved drawing again removes its approval, and it needs approving again.

Changing or removing what you taught

  1. Open Settings, and go to Learned symbols and codes. Every tag code, layer, symbol and block your team has taught is listed, with what it is read as, who set it and when.
  2. Each learned symbol shows a picture of it, and Taught on names the drawing it was taught on, with a link to it. Symbols taught before this was recorded say "Picture not recorded".
  3. Click Change to give it another type, or Remove to forget it.

Who can do this

Teaching is a team lead's or an admin's job, because it changes how every later drawing in the firm is counted. A junior sees what is unknown, and asks a team lead or an admin to set it.

Watch it done

Open on YouTube

The same steps, on the sample tender, in 1:58.

TrueQty Academy/CH 11/Teach it your consultant's codes

Finished this guide?

Mark it done to track your way through the Academy.

Follow along on your own tender. Every guide works the same on a real drawing.

Start free trial