How TrueQty reads your riser: racks, switches and the system view
File the riser, check what TrueQty read from it, and use the system view to see that the plans and the riser agree, rack by rack.
- Who can do this
- JuniorTeam leadAdmin
- Read first
- Video
- 1:55below the steps
In this guide
- 01File the riser
- 02Racks and switches
- 03Check each reading
- 04Plans against riser
The floor plans show where the devices are. The riser shows the racks, the switches and the cables. TrueQty reads both, and joins them.
File the riser
- Open the riser. It says Reference only: a schematic or riser is not counted. That is right: a riser draws the system, and its devices are counted on the floor layouts, so nothing on it is counted or approved.
- File it. If TrueQty spotted the riser by itself, it asks Is this a floor layout?: click Keep as reference. Or click Confirm drawing details, set System to Security and What this drawing shows to Schematic or riser, and click Confirm. A riser spans every floor, so its floor reads Spans floors.
- Tidy the title if you need to. If the proposed title picked up text such as the printed total from the title block, click Edit drawing details, correct Drawing title, and click Save.
If a drawing kept as reference is really a floor layout, click Count it as a floor layout.
Check what it read
- Go to the project page, and open the Racks and cables tab. System view is the first thing in it: one rack per floor, read from the riser, with the switches on each. It says how many devices have a rack.
- Click Check cable types. The cable types read from the riser are checked, and the cable and containment go into the BOQ. The message says so, with Undo. Checked by mistake? Mark not checked takes them back out.
- Look at each rack. Each one is a reading for you to check, such as "48 of 72 ports used, 24 spare".
- Click Check on each rack. A rack is not in the BOQ until it is checked. Mark not checked undoes it.
Until everything is checked, the tab and the next step on the project page say what is still out of the BOQ, such as "2 racks are not checked, so they are not in the BOQ until checked."
Plans against riser
The system view puts the devices from the plans onto the rack serving their floor. When the two disagree, it shows it in red: More devices than ports: add a switch. When they agree to the port, it says the plan and the riser agree exactly, with no spare capacity.
On the sample tender, Level 02's rack has 72 ports and 73 devices are routed to it, because a camera the consultant labelled but never drew was added in review. Either the consultant missed a camera, or the riser is a switch short.
A read-only seat
A read-only seat can see the racks and cables, but not check or change them. The tab says so at the top.
Next
The cable schedule: one row for every device, with its run length.
Watch it done
Open on YouTubeThe same steps, on the sample tender, in 1:55.
Finished this guide?
Mark it done to track your way through the Academy.
Follow along on your own tender. Every guide works the same on a real drawing.
Start free trial